Gas powered

5 Item(s) Show per page
View as: List  Grid  Sort by Set Descending Direction
Ignition Hall Sensor Tester for Petrol/Gas Engine
$14.95
Out of stock

Rcexl ignitions are supplied as standard equipment on many RC engines and any repairs
or modifications may require the static timing point to be reset or checked
The kit will allow you to check and set your static timing point as specified,It comes with a
LED SHOW and audible (Buzzer) signals.
Rcexl ignition when checking over the magnet in the trigger point. Is to stop the
light-emitting LED and audible buzzer to stop the moment when the ignition spark.
This kit can also be used to check the correct operation of the hall sensor and determine
correct magnet orientation.

Learn More

Add to Wishlist | Add to Compare

Petrol engine CDI/Ignition Tester
$9.90

Product Information


Just plug in this device to the ignition sensor lead coming from your ignition and it will simulate the sensor being triggered.

 

You can then;

 

Test the ignition without running your engine.

 

Check the radio interference without running the engine as it will fire the ignition at the rpm set by the dial on the tester.

 

You could even do a range check for ignition RF without actually running the engine.

 

This device can generate a signal to your ignition from 400rpm to 10000rpm, no more guess work

 

Suitable for DL and RCEXL ignition. May work with other brands that use a similar hall sensor

 
Learn More

Add to Wishlist | Add to Compare

Prop Hub Drill Guides to suit DA DL 3W 100/150cc
$39.00

Prop Hub Drill Guides

CNC Machined

Made of Heated Steel

Cad Plated w/ Gold Irradiate

These hubs have been Heat Treated and have very precision holes. They will last a long time.

The hubs have been engraved and not stamped. The six lines that were also engraved on the face, help you keep track of which pattern you are drilling.

It comes with 2 bolts and washers to secure the hub to the prop for drilling.

Learn More

Add to Wishlist | Add to Compare

Prop Hub Drill Guides to suit DA DL 50cc
$39.00

New

Prop Hub Drill Guides

CNC Machined

Made of Heated Steel

Cad Plated w/ Gold Irradiate

These hubs have been Heat Treated and have very precision holes. They will last a long time.

Learn More

Add to Wishlist | Add to Compare

Rcexl Ignition Tachometer for Petroal/Gas Engine V2.0
$24.90

Instructions:
1.The Y wiring tandem between in the HALL sensor and the ignition.
2.The tachometer plug the other end with Y wire.
3.Connected to ignition power supply and can be displayed
Note:
That connecting plugs do Reinforcement. To prevent vibration.
The hall sensor & tachometer wire Leave from the Ignition high-voltage wire,
And receiver wires over 30cm
Connection tachometer is not recommended after the use of flight,
Best to remove the Y wire to restore the original sensor connection
If ignition have an additional tachometer pinout.
You must be connected to dedicated tachometer signal wire.

Note:
Can not guarantee that other types of ignition can use the tachometer And guarantee accuracy

Learn More

Add to Wishlist | Add to Compare

5 Item(s) Show per page
View as: List  Grid  Sort by Set Descending Direction